Polyol, TDI and Mecl are transferred with the help of geared pumps. These pumps are good quality Indian pumps.
- Raw Material Tanks Stainless Steel
| S. No. |
Chemical |
Quantity |
Capacity |
| i) |
Water |
1 Tank |
300 Ltrs. |
| ii) |
Amine |
1 Tank |
200 Ltrs. |
| iii) |
SO |
1 Tank |
200 Ltrs. |
| iv) |
Silicone |
1 Tank |
200 Ltrs. |
| v) |
Color |
1 Tank |
100 Ltrs. |
All the chemicals are metered with the help of suitable capacity geared pumps. Maximum output of Polyol pump is 130 K.G. per minute and all other pumps shall have capacities Suited to the above Polyol output for making foam from 10 to 40 density.
TDI, MeCI and Air are calibrated with the help of rotameters while other are calibrated with help of RPM meters.
It is a high-speed pin type stirrer with 25 hp. A.C. motor provided with three changeable pulleys for three different speeds. All the streams are fitted on to the mixing head via 3 way valves having pneumatic controls. Provision for adding 2 streams of Polyol and 3 streams for additional catalyst..
It is made in 4 sections adjustable in height in relation to each other manually by means of a wheel handle. Total length of the plate is 5 meters.
One trough is provided.
The conveyor is made of strong steel frames with 100mm reinforced mild steel on roller chains, driven by 3hp variable speed drive.
It is made from steel pipe covered with 12mm water proof ply-board. The height from the conveyor is 1.8 meters approx. It is made in 6 sections with 3 inspection windows on each side. The width of the tunnel is fixed, between 1350 mm to 2000 mm. This is to be specified at the time of placing the order. It is provided with two powerful suction fans to remove the fumes.
A three meter roller conveyor is provided after the slate conveyor.
Bottom paper feeding support is underneath the conveyor and the side papers are fed from vertical supports located on both sides of the tunnel. All the papers are automatically rewound at the end of tunnel, with the help of re-winders driven by D.C. drives.
Electrical and pneumatic controls are placed side by side for ease of operation. All the motors have start and stop push buttons with indication lights.
|
